|
1. Remove a cogwheel of an intermediate shaft as Removal at installation of cogwheels drive a belt and the tension mechanism is described in Section.
2. Note depth of installation of an epiploon, then drill in it two small apertures opposite each other.
Screw the self-cutting screw in each aperture flat-nose pliers and take an epiploon.
The note
On some models probably it is necessary to remove the bottom internal cover drive a belt.
3. Clear an epiploon casing, наждачной a skin remove teases and roughnesses which can cause epiploon damage.
4. Grease sealing edges of a new epiploon and establish it on the shaft end. Hammer in an epiploon into a casing on the depth noted earlier. Pay attention that if the shaft surface on a place of a contact of an epiploon has been strongly developed, the new epiploon is necessary for entering into a casing hardly more deeply.
5. Where it is necessary, establish an internal cover of a gear belt, and then - an intermediate pulley and a cogwheel коленвала as Removal at installation of cogwheels drive a belt and the tension mechanism is described in Section.
6. Establish a cogwheel of an intermediate shaft as Removal at installation of cogwheels drive a belt and the mechanism of a tension and new gear приводной a belt is described in Section as Removal, survey and installation gear drive a belt is described in Section. |
Площадки для мероприятий спб на сайте