Renault Megane, Scenic

Since 1996 of release

Repair and car operation

Removal and installation of seats

Forward seats

On the models equipped with system of a tension of seat belts before to start seat removal it is necessary to disconnect the tension mechanism (the Section System of a tension of seat belts of forward seats - the general information see).

REMOVAL

1. Cock a lay brake, then поддомкратьте redock of the car and establish it on props. 2. Working under the car, give four nuts of fastening of a seat. 3. In car salon lift a forward seat, in process of access opening disunite all electric sockets (address to an accompanying illustration). Take a seat from salon.

Back seats

MODELS THE SEDAN (SALOON) AND ХЭТЧБЭК (HATCHBACK)

REMOVAL

1. For pillow removal (ек) a back seat lift it (them) upwards and disconnect lateral forward loops from a floor. 2. For back removal at first remove pillows, then give fixing nuts of loops of a back. Liberate a back from lock fingers and take it from the car.

COMPARTMENT MODELS (COUPE)

REMOVAL

1. Open a ware compartment of a back seat, then delay a felt cover and give fixing nuts (address to an accompanying illustration). 2. By means of flat-nose pliers take fixing clamps of the left and right lateral sections of a pillow of a back seat, then take a pillow from the car (address to an accompanying illustration). 3. Give fixing nuts and take assemblage of a back of a seat from the car. If the seat is taken in gathering, it is necessary to give the main nuts of three loops if one of lateral sections is subject to removal only, give a nut of a corresponding lateral loop and a corresponding lateral small nut of the central loop (address to an accompanying illustration).

INSTALLATION

1. Installation is made upside-down. Track reliability of a tightening of fixture.